|
|
|
Our Services
- Electronic circuit design from concept to
validated schematic, including analog, digital, and mixed-signal systems.
- PCB design and layout optimized for performance, manufacturability, safety,
and EMC/EMI compliance.
- Rapid prototyping using in-house fabrication, assembly, and iterative
testing to reduce development time.
- Functional validation and debugging including electrical measurements,
signal integrity checks, and stress testing.
- Design optimization for production covering component selection, cost
reduction, reliability, and regulatory readiness.
- Conducted and radiated emissions
pre-compliance testing performed to identify potential compliance issues early
in the design phase.
- Immunity pre-compliance evaluation including early or pos fail ESD, EFT/Burst,
Surge, and conducted RF, to assess product robustness.
- Test setup and configuration according to IEC standards providing conditions
closely aligned with accredited laboratory testing.
- Root-cause analysis and troubleshooting using measurement data to locate
emission sources and susceptibility paths.
- Design improvement recommendations supporting corrective actions to increase
the likelihood of first-pass compliance.
- Technical consulting across the product
lifecycle from concept definition through development, validation, and
production.
- Design review and problem analysis identifying performance, reliability,
safety, and EMC-related risks.
- Support for regulatory and standards compliance including guidance on
applicable IEC/EN, and industry requirements.
- Failure analysis and troubleshooting, addressing electrical, functional, and
EMC issues in existing designs.
- Independent engineering expertise, providing objective recommendations and
practical solutions for complex technical challenges.
- Live and recorded technical training sessions
covering electronics design, measurement techniques, and EMC fundamentals.
- Practical, application-focused content based on real laboratory experience
and industry case studies.
- Structured courses and webinars, for engineers, technicians, and
technical managers.
- Custom training programs, specific products, standards, or organizational
needs.
- Interactive sessions with expert guidance, including QMS and practical
recommendations for real-world challenges.
